A Cone with Vivi Gade Design Weaving Paper Strips

#v12845

Vivi Gade Design cones are decorated with Vivi Gade Design weaving paper strips. The weaving paper strips are attached to the cone with double-sided adhesive tape.

#v12845
Sélectionnez des produits pour cette idée

{{ optionsGroup.label }}

{{ getVariantsButtonText(option) }}
   
 
 
   
 
 
   
 
 
   
 
 
   
 
 
Prix ​​total
{{ getFormattedBundlePrice() }}

{{ getRewardMessage() }}

Guide step %d
1.   Attach double-sided adhesive tape to the weaving paper strips.
Guide step %d
2.   Attach the weaving paper strips to the cone in a criss-cross pattern.
Guide step %d
3.   Trim the weaving paper strips.
Guide step %d
4.   Assemble the cone with double-sided adhesive tape.
Guide step %d
5.   Attach double-sided adhesive onto another weaving paper strip and place the handle of the cone on top.
Guide step %d
6.   Trim the weaving paper strip according to the length of the handle.
Guide step %d
7.   Attach the handle onto the cone with double-sided adhesive tape.
Guide step %d
8.   Cut a piece of string measuring approx. 2m. Wrap approx. 1.5m of the string around four fingers.
Guide step %d
9.   With the remaining 0.5m wrap this around one, leaving a small loop at the top.
Guide step %d
10.   Pull the end of the string through a needle and push it through the loop at the top.
Guide step %d
11.   Push the needle through the loop a couple of times.
Guide step %d
12.   Feed the needle on the tassel through the cone and glue it onto the inside of the cone at the bottom. Cut off the excess string.
Guide step %d
13.   Arrange four weaving paper strips in a square by pulling the strips alternately outside and into the adjacent strip.
Guide step %d
14.   Take one top strip and bend down over the other strips. Proceed like this with all four strips all the way around.
Guide step %d
15.   Lock the last strip by inserting it into and under the first strip and pulling it through.
Guide step %d
16.   Take the strip on the left and bend it backwards to the left, and press it down.
Guide step %d
17.   - and then bend it forwards. It will look like two triangular roofs.
Guide step %d
18.   Bend these two triangles together.
Guide step %d
19.   Lock by pulling the strip trough.
Guide step %d
20.   Continue like this on the opposite side.
Guide step %d
21.   Cut off the ends as close to the star as possible.
Guide step %d
22.   Attach the flat star onto the cone using double-sided adhesive tape.
Allez aussi explorer dans
Retour
Je fais mes courses comme
Continuer comme guest
Les avantages à se connecter

✔ Votre liste de souhaits personnelle

✔ L’historique de vos commandes

✔ Paiement facile
Les avantages à se connecter

✔️ Vos prix spéciaux

✔️ Des produits réservés aux professionnels

✔️ L’univers marketing B2B
Les avantages à se connecter

✔ Des contenus spécialement conçus pour vous

✔ Vos prix spéciaux
Copyright © 2024 | CreaVea | 70 Avenue de Clichy | 75017 Paris | France | +33 800 90 91 01 | service-client@creavea.com