A Leather Bracelet with faceted Beads and Nylon Fishing Line Cord
#v13283
This bracelet is made from a long doubled over piece of leather cord. Metallic, faceted beads threaded onto a piece of nylon fishing line cord. The nylon fishing line cord is thentied around the piece of leather cord. A crystal bead is attached at one end and a loop is made at the other end as a fastener. Tie the bracelet twice around the wrist.
#v13283
Comment faire Téléchargez nos instructions étape par étape
1. Cut a piece of 2mm leather cord measuring approx. 110cm and double it over. Tie a knot at one end (i.e. the middle of the leather cord) creating a loop. The size of the loop should correspond to the size of the crystal bead. Now secure the loop onto the top of the clip board and secure both opposite ends of the leather cord at the bottom of the clip board.
2. Cut a piece of nylon fishing line cord measuring approx. 210cm. Double it over and place the middle of this nylon fishing line cord on the clip board underneath the leather cord knot. There are now two equal length ends of nylon fishing line cord on either side of the doubled-over leather cord knot. Place a faceted bead between the two leather cords and pass each end of the nylon fishing line cord over each leather cord and then through the hole of the bead from opposite ends – and finally back to the starting point underneath the leather cords.
3. Tighten each side of the nylon fishing line cord and push the faceted bead into place. Continue the process with a new bead until the bracelet has reached the desired length. NB: in this example where the bracelet is meant to go around the wrist twice, continue the procedure until the bracelet is 35cm long.
4. When the bracelet has reached the desired length, secure the nylon fishing line cord with two or three double knots.
Allez aussi explorer dans