Vivi Gade Design Figures and Shapes on a Metal Stand.

#v12635

Cut out pieces of Vivi Gade Design Fabric using the template and sew these together. Then glue them onto a metal stand in pairs.

#v12635
Sélectionnez des produits pour cette idée

{{ optionsGroup.label }}

{{ getVariantsButtonText(option) }}
   
 
 
   
 
 
   
 
 
   
 
 
   
 
 
Prix ​​total
{{ getFormattedBundlePrice() }}

{{ getRewardMessage() }}

Comment faire
Guide step %d
1.   Draw the template onto Vivi Gade Design Cotton Fabric and cut out.
Guide step %d
2.   Cut out a small square in a different colour or design and sew this onto the cut-out fabric bird.
Guide step %d
3.   Put the two cut-out fabric bird pieces together and sew them together. Leave a small hole.
Guide step %d
4.   Fill the bird with polyester stuffing and sew the hole together.
Guide step %d
5.   Stitch a threaded needle through a button and then through the corner of the small square on the bird.
Guide step %d
6.   And back up again through the button.
Guide step %d
7.   Tie a knot on the piece of thread.
Guide step %d
8.   Trim the ends.
Guide step %d
9.   Push the fabric bird over the metal bar and glue in place.
Guide step %d
10.   Tie a piece of natural hemp around the metal bar where the bird joins, and trim.
Guide step %d
Gabarit   -
Pièce jointe: Télécharger
Allez aussi explorer dans
Copyright © 2024 | CreaVea | 70 Avenue de Clichy | 75017 Paris | France | +33 800 90 91 01 | service-client@creavea.com