Braided bracelet

1   Pull the heart onto a piece of cord – use a beading needle if necessary.

2   Cut two pieces of cord each measuring 90cm and braid on either side of the heart.

3   Braid until the bracelet is a couple of cm short of reaching around your arm.

4   Fasten the cord, which is braided around, on the back.

5   Cut off the end and melt it with a lighter. Press it immediately into the bracelet with the pointed end of a scissors.

6   Arrange the 2 x 2 ends in parallel. Braid around these with a new piece of cord. Fasten the ends and melt them.

7   The bracelet must be able to go over your hand before tying double knots on the four ends. Melt the ends of the knots carefully.